Training & Workshops

Workshop

Epson SPEL + Language Programming

Course Description

Epson's Core SPEL+ language programming class covering commands used on current software releases 5.0, 6.0 and 7.0 on RC90, RC180, RC620 and RC700A controllers. Specific user active controller model reservation is not considered, all current SPEL+ students are welcome. Please be sure to specify your robot model and serial number when registering for class.

Session Length

9:00am-5:00pm

Class Dates & Location:

February 4-6, 2019 - Charlotte, NC 

$1295.00 / per student


August 19-21, 2019 - Greenville, SC 

$1295.00 / per student



CIMTEC AUTOMATION TRAINING CANCELLATION POLICY:

Canceling or rescheduling at least 2 weeks prior to the start of class will allow us to fully refund tuition or apply credit to another class. With less than 2 weeks notice, cancellations are subject to a 75% fee and rescheduling is subject to a 50% fee. Full tuition will be charged for failing to show up for a class without notice or for leaving a class prematurely. Substitutions of one student for another who cannot make the class are accepted at any time, without charge.

Cimtec Automation reserves the right to cancel any course at least 2 weeks prior to the class. In this event, you will be notified and a full refund will be awarded. However, CIMTEC AUTOMATION IS NOT RESPONSIBLE FOR ANY EXPENSES RELATED TO NON-REFUNDABLE AIRLINE TICKETS OR TRAVEL ARRANGEMENTS. Please do not make non-refundable travel arrangements earlier than two weeks before the class start date.