Training & Workshops


Epson Controller Maintenance SCARA Training

Course Description

Robot / Controller Maintenance Course 2.5 days includes complete robot disassembly and assembly including harmonic drives. Robot calibration and teach point robot commands are covered along with preventive maintenance, resolvers/encoders (absolute) robot calibration, and configuration management. Controller and component test/identification replacement procedures. Final day covers detailed troubleshooting labs and spare parts review. Covered Controller models: RC90 / RC170 / RC180 / RC620+ / RC700A

Session Length

Day 1: 8:00am-5:00pm
Day 2: 8:00am-5:00pm
Day 3: 8:00am-12:00pm

Class Dates & Location:

March 2-4, 2021 - Charlotte, NC 

June 8-10, 2021 - Greenville, SC 

October 12-14, 2021 - Charlotte, NC 

$1795.00 / per student


Canceling or rescheduling at least 2 weeks prior to the start of class will allow us to fully refund tuition or apply credit to another class. With less than 2 weeks notice, cancellations are subject to a 75% fee and rescheduling is subject to a 50% fee. Full tuition will be charged for failing to show up for a class without notice or for leaving a class prematurely. Substitutions of one student for another who cannot make the class are accepted at any time, without charge.

Cimtec Automation reserves the right to cancel any course at least 2 weeks prior to the class. In this event, you will be notified and a full refund will be awarded. However, CIMTEC AUTOMATION IS NOT RESPONSIBLE FOR ANY EXPENSES RELATED TO NON-REFUNDABLE AIRLINE TICKETS OR TRAVEL ARRANGEMENTS. Please do not make non-refundable travel arrangements earlier than two weeks before the class start date.